Installation [12/2017 - ]: Procedure

INSTALL ELECTRIC WATER PUMP ASSEMBLY
1. Install the electric water pump assembly to the water pump bracket sub-assembly with the 2 bolts.
  Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
INSTALL WATER PUMP BRACKET SUB-ASSEMBLY
1. for 2WD:
  1. Install the water pump bracket sub-assembly with the 3 bolts.
    Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
2. for AWD:
  1. Install the water pump bracket sub-assembly with the 3 bolts.
    Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
3. Connect the connector and attach the clamp.
CONNECT INTERCOOLER COOLING WATER INLET HOSE
1. Connect the intercooler cooling water hose to the electric water pump assembly, and slide the clip to secure the hose.
  NOTE:
  - Install so that the intercooler cooling water hose paint mark and electric water pump assembly positioning stopper are securely overlapped.
  - Install the clip so that it faces the rear of the vehicle from the intercooler cooling water inlet hose.
INSTALL INTERCOOLER RESERVE TANK ASSEMBLY
Refer to PROCEDURE - Step 33
INSTALL AIR CLEANER ASSEMBLY LH
Refer to PROCEDURE - Step 127 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 127 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 127 [10/2020 - 10/2023] , or refer to PROCEDURE - Step 127 [10/2023 - ]
INSTALL RADIATOR SUPPORT TO CROSSMEMBER BRACE SUB-ASSEMBLY RH
Refer to PROCEDURE - Step 7
INSTALL RADIATOR SUPPORT TO CROSSMEMBER BRACE SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 8
INSTALL LOWER RADIATOR AIR DEFLECTOR
Refer to PROCEDURE - Step 8
INSTALL UPPER RADIATOR SUPPORT SEAL
Refer to PROCEDURE - Step 9
INSTALL RADIATOR COVER PLATE
Refer to PROCEDURE - Step 10
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 192 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 192 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 193 [10/2020 - 10/2023] , or refer to PROCEDURE - Step 192 [10/2023 - ]
ADD COOLANT (for Intercooler)
Refer to PROCEDURE - Step 5
INSPECT FOR COOLANT LEAK (for Intercooler)
See step 1