Removal [10/2022 - 10/2023]: Procedure
- PRECAUTION NOTE:
After the engine switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
- REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
Refer to PROCEDURE - Step 25
- REMOVE LUGGAGE COMPARTMENT FLOOR MAT
Refer to PROCEDURE - Step 24
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to REMOVAL [10/2022 - 10/2023]
- REMOVE FAN AND GENERATOR V BELT
Refer to REMOVAL [12/2017 - ]
- DISCONNECT NO. 3 ENGINE WIRE
Refer to PROCEDURE - Step 59
- REMOVE AIR CLEANER SUPPORT BRACKET ASSEMBLY
- REMOVE GENERATOR ASSEMBLY
- Remove the bolt and disconnect the engine wire.
- Remove the terminal cap.
- Detach the clamp.
- Remove the nut and disconnect the engine wire from terminal B.
- Disconnect the generator assembly connector.
- Remove the 4 bolts and disconnect the wire harness.
*A for 2WD *B for AWD - Remove the 2 bolt and 2 nuts.
- Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator assembly.
- Remove the generator assembly as shown in the illustration.
Vehicle front side
- Remove the bolt and disconnect the engine wire.