Remote Touch Screen Does not Generate Vibration Feedback [12/2017 - 10/2022]: Procedure

1. Using the multi-display customize setting screen, check that the remote touch screen vibration feedback reaction force setting is not set to "Off".

   Refer to CUSTOMIZE PARAMETERS [12/2017 - 10/2022]

   OK

   The remote touch screen vibration feedback reaction force setting is not set to "Off".

   Result

   Proceed to
   OK
   NG

Result: 

NG 

CUSTOMIZE SETTING. Refer to  CUSTOMIZE PARAMETERS [12/2017 - 10/2022] 

Result: 

OK 

See step  2

1. Enter self-diagnostic mode.

   Refer to OPERATION CHECK [12/2017 - 10/2020] , or refer to OPERATION CHECK [10/2020 - 10/2022]

2. Operate the remote touch screen laterally and check that the touch screen generates vibration feedback.
   NOTE:

   Since the remote touch screen may recognize a pinch in/out or flick operation if operated with 2 fingers, always use 1 finger to operate the remote touch in self-diagnostic mode.

   OK

   Remote touch screen generates vibration feedback.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE REMOTE OPERATION CONTROLLER ASSEMBLY (REMOTE TOUCH). Refer to  REMOVAL [12/2017 - 10/2022] 

Result: 

OK 

See step  3

1. Replace the navigation ECU with a new one.

   Refer to REMOVAL [12/2017 - 10/2022]

2. Check the malfunction disappears.

   OK

   Malfunction disappears.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (NAVIGATION ECU IS DEFECTIVE) 

Result: 

NG 

REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [12/2017 - 10/2022]