LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> LS 500 Base, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Electronically Controlled Brake System (W/ Vacuum Brake Booster) - Diagnostic Codes (3 Of 4) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/ Vacuum Brake Booster) >> DTC C1415: Rear Speed Sensor RH Output Malfunction; DTC C1416: Rear Speed Sensor LH Output Malfunction [12/2017 - 09/2018] >> Description

DTC C1415: Rear Speed Sensor RH Output Malfunction; DTC C1416: Rear Speed Sensor LH Output Malfunction [12/2017 - 09/2018]: Description

The speed sensor detects wheel speed and sends the appropriate signals to the skid control ECU (brake actuator assembly). These signals are used for brake control.

Speed sensor rotors have rows of alternating N and S magnetic poles, and their magnetic fields change when the rotors turn.

Each speed sensor detects that magnetic change and sends a pulse signal to the skid control ECU (brake actuator assembly).

HINT: 

When the connectors between the speed sensor and skid control ECU (brake actuator assembly) are connected, the following waveform is output.

GTY784956Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DTC No. Detection Item DTC Detection Condition Trouble Area Note
C1415 Rear Speed Sensor RH Output Malfunction Any of the following is detected:
  • An open in the sensor signal circuit of a malfunctioning area occurs 255 times or more.
  • At a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds.
  • At a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation for 15 seconds or more.
  • Rear speed sensor RH
  • Skid control sensor wire RH
  • Sensor installation
  • Rear speed sensor rotor RH (rear axle hub and bearing assembly RH)
  • Skid control ECU (brake actuator assembly)
  • Wire harness or connector
-
C1416 Rear Speed Sensor LH Output Malfunction Any of the following is detected:
  • An open in the sensor signal circuit of a malfunctioning area occurs 255 times or more.
  • At a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds.
  • At a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation for 15 seconds or more.
  • Rear speed sensor LH
  • Skid control sensor wire LH
  • Speed sensor circuit
  • Sensor installation
  • Rear speed sensor rotor LH (rear axle hub and bearing assembly LH)
  • Skid control ECU (brake actuator assembly)
  • Wire harness or connector
-
C1415 DTC DETECTION CONDITIONS

  Vehicle Condition
Pattern 1 Pattern 2 Pattern 3
Diagnosis Condition - - - -
Malfunction Status An open in the sensor signal circuit of a malfunctioning area occurs 255 times or more ◦ - -
At a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds - ◦ -
At a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation - - ◦
Detection Time - - 15 seconds or more.
Number of Trips 1 trip 1 trip 1 trip

HINT: 

DTC will be output when conditions for either of the patterns in the table above are met.

C1416 DTC DETECTION CONDITIONS

  Vehicle Condition
Pattern 1 Pattern 2 Pattern 3
Diagnosis Condition - - - -
Malfunction Status An open in the sensor signal circuit of a malfunctioning area occurs 255 times or more ◦ - -
At a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds - ◦ -
At a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation - - ◦
Detection Time - - 15 seconds or more.
Number of Trips 1 trip 1 trip 1 trip

HINT: 

DTC will be output when conditions for either of the patterns in the table above are met.