LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> LC 500h >> Repair and Diagnosis >> Maintenance >> Procedures >> Maintenance - Service Information >> Auxiliary Battery >> Removal [05/2023 - ] >> Procedure

Removal [05/2023 - ]: Procedure

  1. PRECAUTION 
    NOTE:
    • After the power switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

      Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]

    • When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.
    • After replacing the auxiliary battery, install the ventilation hole plug supplied with the new battery or the ventilation hole plug from the old battery to the ventilation hole on the side to which the battery hose is not connected.
  2. REMOVE NO. 2 DECK BOARD 

    Refer to PROCEDURE - Step 11

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    1. Loosen the nut, and disconnect the cable from the negative (-) auxiliary battery terminal.
      GTY785069Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE AUXILIARY BATTERY 
    1. Disengage the claw and disconnect the battery terminal cap.
      GTY785073Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Loosen the nut and disconnect the cable from the positive (+) auxiliary battery terminal.
      GTY829455Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 2 nuts and battery clamp sub-assembly.
      GTY829454Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the battery exhaust hose from the auxiliary battery.
      GTY785071Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the auxiliary battery.
scientia non olet · About LEMON Manuals