Removal [03/2017 - ]: Procedure

Refer to PROCEDURE - Step 4 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 4 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 4 [04/2020 - 05/2023] , or refer to DISASSEMBLY [05/2023 - ]

Refer to PROCEDURE - Step 6 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 6 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 6 [04/2020 - 05/2023] , or refer to DISASSEMBLY [05/2023 - ]

1. Detach the wire harness clamp.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Remove the 5 screws and pull handle.
3. Detach the wire harness clamp and disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

4. Remove the 3 screws.
5. Detach the claw and remove the multiplex network master switch assembly with switch base.

6. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Using a thin-bladed screwdriver, detach the claw and remove the multiplex network master switch assembly from the switch base.

   HINT: 

   Tape the thin-bladed screwdriver tip before use.