LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> LC 500 >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (Coupe) (2 Of 2) >> Front Door Belt Moulding >> Removal [03/2017 - 04/2020] >> Procedure

Removal [03/2017 - 04/2020]: Procedure

  1. REMOVE FRONT DOOR TRIM COVER SUB-ASSEMBLY LH (for Driver Side) 

    Refer to PROCEDURE - Step 4 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 4 [06/2019 - 04/2020]

  2. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Driver Side) 

    Refer to PROCEDURE - Step 6 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 6 [06/2019 - 04/2020]

  3. REMOVE FRONT DOOR ASSIST GRIP ASSEMBLY RH (for Front Passenger Side) 

    Refer to PROCEDURE - Step 8 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 8 [06/2019 - 04/2020]

  4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH (for Front Passenger Side) 

    Refer to PROCEDURE - Step 10 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 10 [06/2019 - 04/2020]

  5. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH 

    Refer to PROCEDURE - Step 20 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 20 [06/2019 - 04/2020]

  6. REMOVE FRONT DOOR FRONT LOWER FRAME UPPER COVER LH 

    See step  6

  7. REMOVE FRONT DOOR DIVISION BAR SEAL LH 

    Refer to PROCEDURE - Step 26 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 26 [06/2019 - 04/2020]

  8. REMOVE FRONT DOOR WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 28 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 28 [06/2019 - 04/2020]

  9. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH 
    1. Apply protective tape as shown in the illustration.
      GTY781746Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      Protective Tape
    2. Using a screwdriver with its tip wrapped with protective tape, detach the guides.
    3. Detach the claws to remove front door belt moulding assembly LH.
scientia non olet · About LEMON Manuals