Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the luggage door opening cancel switch assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED / INSTALLED / REPLACED
| Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane-keeping assist system | Refer to INITIALIZATION [03/2017 - 05/2023] |
| Pre-collision system | |||
| Parking assist monitor system | Refer to INITIALIZATION [03/2017 - 05/2023] | ||
| Steering sensor zero point calibration | Variable gear ratio steering system | Refer to INITIALIZATION [03/2017 - ] |