Disposal [03/2017 - ]: Procedure

DISPOSE OF HOOD SUPPORT ASSEMBLY LH

NOTE:

Make sure the piston rods are in the fully extended stake before performing work.

Horizontally hold the hood support assembly LH in a vise with the piston rod pulled out.

Wear safety glasses. Gradually cut a part between A and B shown in the illustration using a metal saw to release the gas.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Area	Measurement
A-B	10 mm (0.394 in.)

WARNING:

Always use proper safety equipment and be careful when drilling because shards of metal may fly about.

HINT:

The gas is colorless, odorless and non-poisonous.