Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the hood lock control cable assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedures	Necessary Procedures	Effect/Inoperative Function when Necessary Procedures are not Performed	Link
Front bumper assembly (Including removal and installation) Radiator grille assembly (Including removal and installation) Front television camera assembly (Including removal and installation)	Front television camera view adjustment	Panoramic view monitor system	Refer to CALIBRATION [05/2023 - ]
Front television camera assembly, radiator grille assembly or front bumper assembly Television camera assembly Side television camera assembly LH or outer rear view mirror assembly LH Side television camera assembly RH or outer rear view mirror assembly RH	Television camera view adjustment HINT: Replacement or removal and installation of 2 or more parts	Panoramic view monitor system	Refer to CALIBRATION [05/2023 - ]