Inspection [03/2017 - ]: Procedure
- INSPECT OUTSIDE DOOR HANDLE SUB-ASSEMBLY LH
- Check the resistance of the outside door handle sub-assembly LH.
*a Component without harness connected
(Outside Door Handle Sub-assembly LH)- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 (LSW) - 4 (LSWG) Pop up condition Below 1 Ω Retracted 4 MΩ or higher 2 (USW) - 5 (USWG) Pop up condition 4 MΩ or higher Retracted Below 1 Ω 3 (POSI) - 6 (PSIG) Pop up condition Below 1 Ω Retracted 4 MΩ or higher If the result is not as specified, replace the outside door handle sub-assembly LH.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Outside Door Handle Sub-assembly LH)Check the pop up operation.
- Check the retracted and pop up condition of the outside door handle assembly LH when the battery voltage is applied to the connector terminal.
OK
Measurement Condition Specified Condition Battery positive (+) → 1 (MRT+)
Battery negative (-) → 2 (MRT-)Pop up condition Battery negative (-) → 1(MRT+)
Battery positive (+) → 2 (MRT-)Retracted If the result is not as specified, replace the outside door handle sub-assembly LH.
- Check the retracted and pop up condition of the outside door handle assembly LH when the battery voltage is applied to the connector terminal.
- Check the resistance of the outside door handle sub-assembly LH.
- INSPECT OUTSIDE DOOR HANDLE SUB-ASSEMBLY RH
*a Component without harness connected
(Outside Door Handle Sub-assembly RH)Check the resistance of the outside door handle sub-assembly RH.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 (LSW) - 4 (LSWG) Pop up condition Below 1 Ω Retracted 4 MΩ or higher 2 (USW) - 5 (USWG) Pop up condition 4 MΩ or higher Retracted Below 1 Ω 3 (POSI) - 6 (PSIG) Pop up condition Below 1 Ω Retracted 4 MΩ or higher If the result is not as specified, replace the outside door handle sub-assembly RH.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Outside Door Handle Sub-assembly RH)Check the pop up operation.
- Check the retracted and pop up condition of the outside door handle assembly RH when the battery voltage is applied to the connector terminal.
OK
Measurement Condition Specified Condition Battery positive (+) → 1 (MRT+)
Battery negative (-) → 2 (MRT-)Pop up condition Battery negative (-) → 1(MRT+)
Battery positive (+) → 2 (MRT-)Retracted If the result is not as specified, replace the outside door handle sub-assembly RH.
- Check the retracted and pop up condition of the outside door handle assembly RH when the battery voltage is applied to the connector terminal.