Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front door disassembly/reassembly are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedures	Effect/Inoperative Function when Necessary Procedures are not Performed	Link
Power window regulator motor assembly Front door window regulator sub-assembly Door glass Door glass run	Initialize power window control system	Auto up and down function Jam protection function Catch protection function Remote control function Key-linked function Key-off operation function Window open warning function	Refer to INITIALIZATION [03/2017 - ]
Outer rear view mirror assembly LH (Including removal and installation) Outer rear view mirror assembly RH (Including removal and installation)	Side television camera view adjustment	Panoramic view monitor system	Refer to CALIBRATION [05/2023 - ]
Front television camera assembly, radiator grille assembly or front bumper assembly Television camera assembly Side television camera assembly LH or outer rear view mirror assembly LH Side television camera assembly RH or outer rear view mirror assembly RH	Television camera view adjustment HINT: Replacement or removal and installation of 2 or more parts	Panoramic view monitor system	Refer to CALIBRATION [05/2023 - ]

HINT:

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
Lane tracing assist system	Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.	Refer to INITIALIZATION [05/2023 - ]
Pre-collision system		Refer to INITIALIZATION [05/2023 - ]
Variable gear ratio steering system		Refer to INITIALIZATION [03/2017 - ]

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
Air conditioning system	After the engine switch is turned to ON, the servo motor standard position is recognized.	-

Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.