LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> LC 500 >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System (Ext) - Service Information (Coupe) >> Stop Light Switch >> Removal [05/2023 - ] >> Procedure

Removal [05/2023 - ]: Procedure

  1. REMOVE NO. 2 DECK BOARD 

    Refer to PROCEDURE - Step 12

  2. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing.

    GTY607029Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Refer to PRECAUTION [05/2023 - ]

    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 3

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    • If the airbag deploys for any reason, it may cause a serious accident.
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 16

  5. REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU 

    Refer to REMOVAL [05/2023 - ]

  6. REMOVE STOP LIGHT SWITCH ASSEMBLY 
    1. GTY817984Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Disconnect the connector.

    2. Turn the stop light switch assembly counterclockwise and remove it.
  7. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER 
    1. Using a screwdriver, detach the claw and remove the stop light switch mounting adjuster.
      GTY820090Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
      NOTE:

      The stop light switch mounting adjuster must not be reused.

      HINT: 

      Tape the screwdriver tip before use.

scientia non olet · About LEMON Manuals