Installation [05/2023 - ]: Procedure

INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

Attach the claw to install a new stop light switch mounting adjuster.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL STOP LIGHT SWITCH ASSEMBLY

Insert the stop light switch assembly to the stop light switch mounting adjuster until the switch body slightly touches the brake pedal.

NOTE:

Do not depress the brake pedal.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Rotate the stop light switch assembly clockwise by approximately one fourth of a rotation.

*a	Protrusion Amount Measurement Area

Check the protrusion amount of the shaft.
Standard

1.5 to 2.6 mm (0.0591 to 0.1024 in.)
Connect the connector.

INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU
Refer to INSTALLATION [05/2023 - ]
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 35
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2
INSTALL NO. 2 DECK BOARD
Refer to PROCEDURE - Step 13
PERFORM DIAGNOSTIC SYSTEM CHECK
Refer to DTC CHECK / CLEAR [04/2020 - ]
CHECK SRS WARNING LIGHT
Refer to OPERATION CHECK [04/2020 - ]
INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [05/2023 - ]