LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> IS 350 Base, RWD >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Engine Starting System (2GR-FKS) - Service Information >> Starter >> Removal [10/2017 - ] >> Procedure

Removal [10/2017 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [10/2017 - 09/2020] , or refer to PRECAUTION [09/2020 - ]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [10/2017 - 09/2020] , or refer to INITIALIZATION [09/2020 - 11/2021] , or refer to INITIALIZATION [11/2021 - 09/2022] , or refer to INITIALIZATION [09/2022 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]

  3. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst) 

    Refer to REMOVAL [10/2017 - ]

  4. REMOVE STARTER COVER 
    1. Remove the 2 bolts and starter cover.
      GTY627223Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE STARTER ASSEMBLY 
    1. Disconnect the starter connector.
      GTY838166Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Open the terminal cap, remove the nut and disconnect the wire harness.
    3. Remove the 2 bolts and starter assembly.