Entire Combination Meter does not Operate [04/2013 - ]: Procedure

1. Disconnect the K3 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K3-31 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   K3-21 (IG+) - Body ground	Engine switch off	Below 1 V
   	Engine switch on (IG)	11 to 14 V
   K3-22 (B) - Body ground	Always	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [04/2013 - 10/2016]  , or refer to  REMOVAL [10/2016 - 09/2020]  , or refer to  REMOVAL [09/2020 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR