LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> GX 460 Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display System (Diagnostics - Introduction) (2 Of 2) >> Meter / Gauge System >> Operation Check [08/2019 - ] >> Operation Check [08/2019 - ]

Operation Check [08/2019 - ]

  1. CHECK INDICATOR/WARNING LIGHT 
    1. Check the following indicators and warning lights.
      Indicator/Warning Light Component Specified Condition
      Automatic high beam indicator light Main body ECU (multiplex network body ECU) Engine switch off → Engine switch on (IG), comes on for 3 seconds
      Downhill assist control indicator light Master cylinder solenoid (skid control ECU)
      ABS warning light Master cylinder solenoid (skid control ECU)
      TRAC OFF indicator light Master cylinder solenoid (skid control ECU)
      Brake warning light Master cylinder solenoid (skid control ECU)
      Slip indicator light Master cylinder solenoid (skid control ECU)
      VSC OFF indicator light Master cylinder solenoid (skid control ECU)
      BSM indicator light Blind spot monitor sensor RH
      PCS OFF indicator light Driving support ECU assembly
      Eco drive indicator light ECM
      Kinetic dynamic suspension system indicator light Stabilizer control ECU
      SRS warning light Airbag sensor assembly Engine switch off → Engine switch on (IG), comes on for 6 seconds
      Charge warning light Generator assembly
      • Illuminates when engine switch turned on (IG)
      • Turns off when engine started
  2. CHECK SPEEDOMETER 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
      ABS/VSC/TRAC

      Tester Display Measurement Item / Range Normal Condition Diagnostic Note
      Vehicle Speed Vehicle speed / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed -
      FOR KM/H

      Standard Indication (km/h) Acceptable Range (km/h)
      20 18.5 to 22.5
      40 38.9 to 43.4
      60 59.4 to 63.8
      80 79.6 to 84.6
      100 100.1 to 105.1
      120 120.7 to 125.7
      140 141.2 to 146.2
      160 161.7 to 166.7
      180 182.3 to 187.3
      FOR MPH

      Standard Indication (mph) Acceptable Range (mph)
      20 19.3 to 21.8
      40 39.7 to 42.5
      60 59.8 to 63
      80 80.5 to 83.7
      100 101 to 104.2
      120 121.8 to 124.8
      NOTE:

      Do not use worn, underinflated or overinflated tires as the speedometer reading will be inaccurate.

    5. Check the deflection width of the speedometer indicator.

      Reference

      Within 0.3°

  3. CHECK TACHOMETER 
    1. Connect a tune-up tachometer and start the engine.
    2. Compare the test results with the tachometer indicator.
      DC 13.5 V AT 25°C (77°F)

      Standard Indication (rpm) Acceptable Range
      Data in () is for Reference (rpm)
      700 630 to 770
      1000 (900 to 1100)
      2000 (1850 to 2150)
      3000 2800 to 3200
      4000 (3800 to 4200)
      5000 4800 to 5200
      6000 (5750 to 6250)

      If the result is not as specified, the tachometer may have a malfunction.

scientia non olet · About LEMON Manuals