DTC B124B: Automatic High Beam System [10/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: System Select / Health Check.
5. Check for DTCs.

   Result

   Result	Proceed to
   Only DTC B124B is output	A
   DTC B124B and other DTCs are output	B

Result:  2

B 

GO TO OTHER DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [10/2015 - ] 

Result:  1

A 

See step  2

1. Check if a dynamic radar cruise control system, LKA/LDA system and pre-collision system warning message is displayed on the combination meter assembly.

   Refer to DIAGNOSIS SYSTEM [10/2015 - ]

   OK

   No dynamic radar cruise control system, LKA/LDA system and pre-collision system warning messages are displayed.

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [09/2014 - ] 

Result:  2

NG 

GO TO FORWARD RECOGNITION CAMERA SYSTEM. Refer to  SYSTEM DESCRIPTION [10/2015 - ]