Automatic High Beam Switch Circuit [10/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the Data List according to the display on the Techstream.
   MAIN BODY
   
   

   Tester Display	Measurement Item	Range	Normal Condition
   Auto High Beam Main Switch	Integration control and panel assembly (automatic high beam switch) signal	ON or OFF	ON: Integration control and panel assembly (automatic high beam switch) pressed OFF: Integration control and panel assembly (automatic high beam switch) not pressed

   OK

   Normal conditions listed above are displayed.

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2015 - ] 

Result:  2

NG 

See step  2

1. Remove the integration control and panel assembly (automatic high beam switch).

   Refer to REMOVAL [10/2015 - ]

2. Inspect the integration control and panel assembly (automatic high beam switch).

   Refer to INSPECTION [10/2015 - ]

   OK

   Integration control and panel assembly (automatic high beam switch) is normal.

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY (AUTOMATIC HIGH BEAM SWITCH). Refer to  REMOVAL [10/2015 - ] 

Result:  1

OK 

See step  3

1. Disconnect the N13 main body ECU (multiplex network body ECU) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   N6-7 (+B) - N13-17 (AHBI)	Always	Below 1 Ω
   N6-7 (+B) or N13-17 (AHBI) - Body ground	Always	10 kΩ or higher
   N6-8 (E) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [09/2014 - ] 

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR