LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2018 >> ES 300h >> Repair and Diagnosis >> Electrical >> Gauges >> Meter / Gauge System (Service Information) >> Clock >> Removal [07/2015 - ] >> Procedure

Removal [07/2015 - ]: Procedure

  1. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column) 
    1. Disable the auto away/return function by changing the customize parameter. Refer to CUSTOMIZE PARAMETERS [07/2015 - ]
      NOTE:

      Record the current customize parameter setting (whether the auto away/return function is enabled or disabled) in order to restore the current setting after finishing this operation.

      HINT: 

      Performing the above operation disables the auto away/return function when the power switch is turned off.

    2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
    3. Turn the power switch off.
  2. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 

    See step  5

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH 

    Refer to PROCEDURE - Step 12

  4. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY 

    Refer to PROCEDURE - Step 13

  5. REMOVE CLOCK ASSEMBLY 
    1. Disengage the 4 claws and remove the clock assembly.
      GTY400048Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals