Inspection [07/2015 - ]: Procedure

INSPECT TRIP SWITCH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
2 (A/B) - 5 (E)	ODO/TRIP switch not pressed	10 kΩ or higher
2 (A/B) - 5 (E)	ODO/TRIP switch pressed	Below 1 Ω
3 (IG) - 5 (E)	Light control rheostat up switch not pressed	10 kΩ or higher
3 (IG) - 5 (E)	Light control rheostat up switch pressed	Below 1 Ω
3 (IG) - 5 (E)	Light control rheostat down switch not pressed	10 kΩ or higher
3 (IG) - 5 (E)	Light control rheostat down switch pressed	Below 1 Ω

Apply auxiliary battery voltage to the terminals of the switch, and check the lighting condition of the trip switch.

Measurement Condition	Condition	Specified Condition
Auxiliary battery positive (+) → 8 (ILL+) Auxiliary battery negative (-) → 6 (ILL-)	Always	Trip switch illumination comes on

TEXT IN ILLUSTRATION

*a	Component without harness connected (Trip Switch)

If the result is not as specified, replace the trip switch.