Removal [08/2016 - 12/2017]: Procedure
- PRECAUTION NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [09/2015 - 12/2017]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL WARNING:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If an SRS part is accidentally deployed, it may cause a serious injury.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [08/2016 - 12/2017]
- REMOVE FRONT DOOR SCUFF PLATE
Refer to PROCEDURE - Step 9
- REMOVE REAR DOOR SCUFF PLATE
Refer to PROCEDURE - Step 11
- REMOVE LOWER CENTER PILLAR GARNISH
Refer to PROCEDURE - Step 12
- DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
- REMOVE CENTER PILLAR GARNISH ASSEMBLY
Refer to PROCEDURE - Step 14
- REMOVE FRONT SEAT OUTER BELT ASSEMBLY
- Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
- Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector.
*a Protective Tape *b Locking Button *c Release HINT:
Tape the screwdriver tip before use.
- Disconnect the connector.
- Remove the 2 bolts.
- Disengage the 2 guides to remove the front seat outer belt assembly.
- Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
- REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY