LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> RC F >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting System (Triple Beam) - Diagnostic Codes & Circuit Tests >> LIGHTING SYSTEM(for Triple Beam Headlight) >> DTC B2443: Lost Communication with Left Headlight and Right Headlight LIN [09/2014 - 03/2019] >> Procedure

DTC B2443: Lost Communication with Left Headlight and Right Headlight LIN [09/2014 - 03/2019]: Procedure

  1. CLEAR DTC 
    1. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [09/2014 - 03/2019]

      Body Electrical > HL AutoLeveling > Clear DTCs 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  2

  2. CHECK FOR DTC 
    1. Turn the engine switch on (IG).
    2. Check for DTCs.

      Refer to DTC CHECK / CLEAR [09/2014 - 03/2019]

      Body Electrical > HL AutoLeveling > Trouble Codes 

      OK

      DTC B2443 is not output.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - 08/2016]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2016 - 11/2017]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2017 - 03/2019] 

    Result: 

    NG 

    See step  3

  3. CHECK HARNESS AND CONNECTOR (HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH - HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY RH) 
    1. Disconnect the A3 headlight light control ECU sub-assembly LH connector.
    2. Disconnect the A11 headlight light control ECU sub-assembly RH connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      A3-20 (LINL) - A11-20 (LINL) Always Below 1 Ω
      A3-20 (LINL) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  4

  4. REPLACE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY RH 
    1. Replace the headlight light control ECU sub-assembly RH with a new or known good one.

      Refer to REMOVAL [09/2014 - 03/2019]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  5

  5. CLEAR DTC 
    1. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [09/2014 - 03/2019]

      Body Electrical > HL AutoLeveling > Clear DTCs 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  6

  6. CHECK FOR DTC 
    1. Turn the engine switch on (IG).
    2. Check for DTCs.

      Refer to DTC CHECK / CLEAR [09/2014 - 03/2019]

      Body Electrical > HL AutoLeveling > Trouble Codes 

      OK

      DTC B2443 is not output.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END (HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY RH WAS DEFECTIVE) 

    Result: 

    NG 

    REPLACE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [09/2014 - 03/2019]