Meter Illumination is Always Dark [10/2018 - ]: Procedure

1. Check if CAN communication DTCs are output.

   Refer to DIAGNOSIS SYSTEM [10/2018 - 11/2019] , or refer to DIAGNOSIS SYSTEM [11/2019 - 09/2020] , or refer to DIAGNOSIS SYSTEM [09/2020 - 10/2022] , or refer to DIAGNOSIS SYSTEM [10/2022 - 10/2023] , or refer to DIAGNOSIS SYSTEM [10/2023 - ]

   Result

   Result	Proceed to
   CAN communication DTCs are not output.	A
   CAN communication DTCs are output.	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2018 - ] 

Result: 

A 

See step  2

1. Check if lighting system DTCs are output.

   Refer to DTC CHECK / CLEAR [10/2018 - ]

   Body Electrical > Main Body > Trouble Codes 

   Result

   Result	Proceed to
   DTC B1244 is not output.	A
   DTC B1244 is output.	B

Result: 

B 

GO TO DTC B1244. Refer to  DTC B1244: Light Sensor Circuit [10/2018 - ] 

Result: 

A 

See step  3

1. Replace the combination meter assembly with a new one.

   Refer to REMOVAL [09/2014 - ]

   OK

   The operation of the combination meter assembly returns to normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [09/2014 - ]