Adjustment [09/2014 - ]: Procedure

Refer to REMOVAL [09/2014 - 11/2017] , or refer to REMOVAL [11/2017 - ]

Refer to PROCEDURE - Step 2

1. Move the shift lever to N.
2. Remove the nut and disconnect the floor shift gear shifting rod sub-assembly from the lever of the transmission floor shift assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Lever

3. Turn the transmission control shaft lever LH clockwise until it stops, then turn it counterclockwise 2 notches.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Transmission Control Shaft Lever LH
   *a	P
   *b	R
   *c	N

4. Temporarily install the nut to the lever of the transmission floor shift assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Lever
   	Rear of the Vehicle

5. Tighten the nut while lightly pushing the lever of the transmission floor shift assembly toward the rear of the vehicle.

   Torque: 12.8 N.m (131 kgf/cm, 9 ft.lbf) 

   NOTE:

   Do not push the lever of the transmission floor shift assembly too hard.

Refer to PROCEDURE - Step 4

Refer to INSTALLATION [09/2014 - 11/2017] , or refer to INSTALLATION [11/2017 - ]

See step  1

Refer to PROCEDURE - Step 9 [09/2014 - 11/2017] , or refer to PROCEDURE - Step 9 [11/2017 - ]