LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> RC 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Automatic Transmission System (8AR-FTS,Aa81E) - Diagnostic Codes (3 Of 3) & Circuit Tests) >> AUTOMATIC TRANSMISSION SYSTEM (for 8AR-FTS) >> Kick Down Switch Circuit [10/2015 - ] >> Procedure

Kick Down Switch Circuit [10/2015 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus RC 300, 2023 Lexus RC 300, 2022 Lexus RC 300, 2021 Lexus RC 300, and 2020 Lexus RC 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK HARNESS AND CONNECTOR (KICK DOWN SWITCH ASSEMBLY - BODY GROUND) 
    1. Disconnect the A53 kick down switch assembly connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      A53-1 - Body ground Always Below 1 Ω

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR (KICK DOWN SWITCH ASSEMBLY - BODY GROUND) 

    Result: 

    OK 

    See step  2

  2. INSPECT KICK DOWN SWITCH ASSEMBLY 
    1. Remove the kick down switch assembly.

      Refer to REMOVAL [10/2015 - 11/2017] , or refer to REMOVAL [11/2017 - ]

    2. Measure the resistance according to the value(s) in the table below.
      GTY646340Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Kick Down Switch Assembly)

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 (E) - 2 (KD) Continuously pressed
      (Kick down switch is on)      		 Below 1 Ω
      Released
      (Kick down switch is off)      		 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE KICK DOWN SWITCH ASSEMBLY. Refer to  COMPONENTS [09/2014 - ] 

    Result: 

    OK 

    See step  3

  3. CHECK HARNESS AND CONNECTOR (KICK DOWN SWITCH ASSEMBLY - ECM) 
    1. Install the kick down switch assembly.

      Refer to INSTALLATION [10/2015 - 11/2017] , or refer to INSTALLATION [11/2017 - ]

    2. Disconnect the A82 ECM connector.
    3. Measure resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      A82-53 (KD) - Body ground Fully depressed
      (Kick down switch is on)      		 Below 1 Ω
      Released
      (Kick down switch is off)      		 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2015 - ] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR (KICK DOWN SWITCH ASSEMBLY - ECM) 

scientia non olet · About LEMON Manuals