DTC P0705-13: Transmission Range Sensor "A" Circuit Open; DTC P0705-62: Transmission Range Sensor "A" Signal Compare Failure [11/2017 - ]: Description
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
The park/neutral position switch assembly detects the shift lever position and sends a signal to the ECM.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P0705-13 | Transmission Range Sensor "A" Circuit Open | When the engine switch is on (IG) and battery voltage is 8 V or more, NSW, P, R, N and D input signals are all OFF simultaneously for 60 seconds or more (2-trip detection logic). |
|
Comes on | DTC stored | SAE Code: P0705 |
| P0705-62 | Transmission Range Sensor "A" Signal Compare Failure | When the engine switch is on (IG) and battery voltage is 8 V or more, 2 or more of the following signals are ON simultaneously for 2 seconds or more (2-trip detection logic).
|
|
Comes on | DTC stored | SAE Code: P0705 |
DTC DETECTION CONDITION PATTERNS (P0705-62):
| Vehicle Condition | |||||
|---|---|---|---|---|---|
| Pattern 1 | Pattern 2 | Pattern 3 | Pattern 4 | ||
| Diagnostic Condition | Engine switch is on (IG) | ◦ | ◦ | ◦ | ◦ |
| Battery voltage is 8 V or more | ◦ | ◦ | ◦ | ◦ | |
| Malfunction Condition | NSW input signal is ON | ◦ | ◦ | - | - |
| P input signal is ON | - | - | ◦ | ◦ | |
| R input signal is ON | - | ◦ | - | ◦ | |
| N input signal is ON | - | - | - | - | |
| D input signal is ON | ◦ | - | ◦ | - | |
| Duration | 2 seconds or more | 2 seconds or more | 2 seconds or more | 2 seconds or more | |
| Detection Logic | 2-trip detection logic | 2-trip detection logic | 2-trip detection logic | 2-trip detection logic | |
DTC DETECTION CONDITION PATTERNS (P0705-62):
| Vehicle Condition | ||||
|---|---|---|---|---|
| Pattern 5 | Pattern 6 | Pattern 7 | ||
| Diagnostic Condition | Engine switch is on (IG) | ◦ | ◦ | ◦ |
| Battery voltage is 8 V or more | ◦ | ◦ | ◦ | |
| Malfunction Condition | NSW input signal is ON | - | - | - |
| P input signal is ON | - | - | - | |
| R input signal is ON | - | ◦ | ◦ | |
| N input signal is ON | ◦ | ◦ | - | |
| D input signal is ON | ◦ | - | ◦ | |
| Duration | 2 seconds or more | 2 seconds or more | 2 seconds or more | |
| Detection Logic | 2-trip detection logic | 2-trip detection logic | 2-trip detection logic | |
HINT:
DTC P0705-62 is stored when any of the above detection patterns is met.