On-Vehicle Inspection [11/2017 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE ENGINE ROOM SIDE COVER
Refer to PROCEDURE - Step 1 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 1 [10/2018 - 10/2022] , or refer to PROCEDURE - Step 1 [10/2022 - ]
- REMOVE COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 2 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 2 [10/2018 - 10/2022] , or refer to PROCEDURE - Step 2 [10/2022 - ]
- REMOVE INLET NO. 1 AIR CLEANER
Refer to PROCEDURE - Step 19
- INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
- Disconnect the engine oil pressure switch assembly connector.
- Start the engine.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - Switch body Idling 10 kΩ or higher 1 - Switch body Engine stopped Below 1 Ω If the result is not as specified, replace the engine oil pressure switch assembly.
- Reconnect the engine oil pressure switch assembly connector.
- INSTALL INLET NO. 1 AIR CLEANER
Refer to PROCEDURE - Step 77
- INSTALL COOL AIR INTAKE DUCT SEAL
Refer to PROCEDURE - Step 2 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 2 [10/2018 - 10/2022] , or refer to PROCEDURE - Step 2 [10/2022 - ]
- INSTALL ENGINE ROOM SIDE COVER
Refer to PROCEDURE - Step 3 [11/2017 - 10/2018] , or refer to PROCEDURE - Step 3 [10/2018 - 10/2022] , or refer to PROCEDURE - Step 3 [10/2022 - ]