LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> RC 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Lubrication System (2GR-FKS) - Service Information) >> Oil Level Sensor >> Removal [11/2017 - ] >> Procedure

Removal [11/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN ENGINE OIL 

    See step  1 [11/2017 - 11/2021], or see step  1 [11/2021 - ]

  2. REMOVE FRONT SUSPENSION MEMBER BRACE (for 2WD) 

    Refer to PROCEDURE - Step 14

  3. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 24

  4. REMOVE OIL PIPE WITH STRAINER SUB-ASSEMBLY (for AWD) 

    Refer to PROCEDURE - Step 25

  5. REMOVE ENGINE OIL LEVEL SENSOR 
    1. Disconnect the engine oil level sensor connector.
      GTY784723Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for 2WD
      *B for AWD
    2. Remove the clip from the engine oil level sensor.
      GTY822869Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for 2WD
      *B for AWD
    3. Disengage the clamp.
      GTY825748Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for 2WD
      *B for AWD
    4. Remove the 2 nuts and engine oil level sensor.
  6. REMOVE OIL LEVEL SENSOR BRACKET 
    1. Remove the oil level sensor bracket.
      GTY779280Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for 2WD
      *B for AWD
scientia non olet · About LEMON Manuals