LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> RC 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Automatic Transmission System (Aa81E) - Service Information (1 Of 2)) >> Shift Lever >> Removal [10/2015 - 11/2017] >> Procedure

Removal [10/2015 - 11/2017]: Procedure

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE SHIFT LEVER CAP 
    1. Using a screwdriver, disengage the 2 claws as shown in the illustration and remove the shift lever cap from the shift position indicator.
      GTY501008Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      NOTE:

      Do not damage the shift lever cap and shift position indicator.

      HINT: 

      Tape the screwdriver tip before use.

  2. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) 
  3. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR 

    Refer to PROCEDURE - Step 3

  4. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY 
    1. Move the shift lever to N.
    2. Remove the nut and disconnect the floor shift gear shifting rod sub-assembly from the lever of the transmission floor shift assembly.
      GTY500008Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Lever
  5. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [09/2014 - 10/2018]

  6. REMOVE NO. 1 CONSOLE BOX DUCT 
    1. Disengage the clamp to disconnect the wire harness from the No. 1 console box duct.
      GTY502761Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 clips and No. 1 console box duct.
      GTY518659Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY 
    1. Disconnect the shift lock control ECU connector.
      GTY512426Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 4 clamps to disconnect the wire harness from the transmission floor shift assembly.
      GTY520785Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the transmission control switch connector.
      GTY502760Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 4 bolts and transmission floor shift assembly from the vehicle body.
      GTY502758Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals