Adjustment [11/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
- for 8AR-FTS:
  Refer to REMOVAL [10/2015 - ]
- for 2GR-FKS:
  Refer to REMOVAL [11/2017 - ]
REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
Refer to PROCEDURE - Step 4

ADJUST SHIFT LEVER POSITION

Move the shift lever to N.

Remove the nut and disconnect the floor shift gear shifting rod sub-assembly from the lever of the transmission floor shift assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Lever

Turn the transmission control shaft lever RH counterclockwise until it stops, then turn it clockwise 2 notches.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Transmission Control Shaft Lever RH
*a	P
*b	R
*c	N

Connect the floor shift gear shifting rod sub-assembly to the lever of the transmission floor shift assembly.

*a	Lever
	Rear of the Vehicle

Temporarily install the nut to the lever of the transmission floor shift assembly.
Tighten the nut while lightly pushing the lever of the transmission floor shift assembly toward the rear of the vehicle.
Torque: 12.8 N.m (131 kgf/cm, 9 ft.lbf)

NOTE:
Do not push the lever of the transmission floor shift assembly too hard.

INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR
Refer to PROCEDURE - Step 5
INSTALL FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
- for 8AR-FTS:
  Refer to INSTALLATION [10/2015 - ]
- for 2GR-FKS:
  Refer to INSTALLATION [11/2017 - ]
INSPECT SHIFT LEVER POSITION
See step 1
INSPECT FOR EXHAUST GAS LEAK
- for 8AR-FTS:
  Refer to PROCEDURE - Step 8
- for 2GR-FKS:
  Refer to PROCEDURE - Step 9