Inspection [09/2014 - 11/2017]: Procedure
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2024 Lexus RC 350, 2024 Lexus RC 300, 2023 Lexus RC 350, 2023 Lexus RC 300, and 2022 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT COMBINATION SWITCH ASSEMBLY
- Inspect the ECO drive mode switch:
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Combination Switch Assembly)Standard Resistance
Tester Connection Condition Specified Condition 11 (ECO) - 16 (E) Combination switch turned and held at ECO position Below 50 Ω Combination switch not turned 1 MΩ or higher If the result is not as specified, replace the combination switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Inspect the NORMAL mode switch:
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 9 (NORM) - 16 (E) Combination switch pushed and held Below 50 Ω Combination switch not pushed 1 MΩ or higher If the result is not as specified, replace the combination switch assembly.
*a Component without harness connected
(Combination Switch Assembly)
- Measure the resistance according to the value(s) in the table below.
- Inspect the SPORT or SPORT S/S+ mode switch:
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 10 (PWR) - 16 (E) Combination switch turned and held at SPORT or SPORT S/S+ position Below 50 Ω Combination switch not turned 1 MΩ or higher If the result is not as specified, replace the combination switch assembly.
*a Component without harness connected
(Combination Switch Assembly)
- Measure the resistance according to the value(s) in the table below.
- Inspect the SNOW mode switch:
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 (SNSW) - 16 (E) SNOW mode switch pushed and held Below 50 Ω SNOW mode switch not pushed 1 MΩ or higher If the result is not as specified, replace the combination switch assembly.
*a Component without harness connected
(Combination Switch Assembly)
- Measure the resistance according to the value(s) in the table below.
- Inspect the VSC off mode switch:
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 (+) - 16 (E) VSC OFF mode switch pushed and held Below 50 Ω VSC OFF mode switch not pushed 1 MΩ or higher If the result is not as specified, replace the combination switch assembly.
*a Component without harness connected
(Combination Switch Assembly)
- Measure the resistance according to the value(s) in the table below.
- Check the illumination:
- Apply battery voltage to the combination switch assembly and check that the combination switch assembly illuminates.
Standard
Measurement Condition Specified Condition Battery positive (+) → 5 (ILL+) Battery negative (-) → 8 (ILL-) Illuminates If the result is not as specified, replace the combination switch assembly.
*a Component without harness connected
(Combination Switch Assembly)*b Combination Switch Assembly Illumination
- Apply battery voltage to the combination switch assembly and check that the combination switch assembly illuminates.
- Inspect the ECO drive mode switch: