LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> RC 300 F Sport >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (2GR-FSE) - Service Information >> Water Pump >> Removal [09/2014 - 11/2017] >> Procedure

Removal [09/2014 - 11/2017]: Procedure

  1. REMOVE GENERATOR ASSEMBLY 

    Refer to REMOVAL [09/2014 - 11/2017]

  2. REMOVE COMPRESSOR AND MAGNETIC CLUTCH (for 2WD) 

    Refer to REMOVAL [09/2014 - 10/2015] , or refer to REMOVAL [10/2015 - 11/2017]

  3. REMOVE COMPRESSOR AND MAGNETIC CLUTCH (for AWD) 

    Refer to REMOVAL [09/2014 - 11/2017]

  4. DRAIN ENGINE COOLANT 

    See step  5 [09/2014 - 10/2015], or see step  5 [10/2015 - 11/2017]

  5. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY 

    Refer to PROCEDURE - Step 12

  6. DISCONNECT NO. 2 RADIATOR HOSE 

    See step  7

  7. REMOVE NO. 1 ENGINE COVER 

    Refer to PROCEDURE - Step 7

  8. REMOVE INJECTOR DRIVER 

    Refer to PROCEDURE - Step 8

  9. REMOVE WATER PUMP PULLEY 
    1. Using SST, hold the water pump pulley.
      GTY461870Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09960-10010 
        1. 09962-01000
        2. 09963-00700
    2. Remove the 4 bolts and water pump pulley.
  10. REMOVE WATER INLET 
    1. Slide the clip and disconnect the No. 2 water by-pass hose from the water inlet.
      GTY467871Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 No. 2 Water By-pass Hose
      *2 No. 3 Water By-pass Hose
      *3 No. 4 Water By-pass Hose
      *4 No. 6 Water By-pass Hose
      *5 Radiator Reserve Tank Hose
    2. Slide the clip and disconnect the No. 3 water by-pass hose from the water inlet.
    3. Slide the clip and disconnect the No. 4 water by-pass hose from the water inlet.
    4. Slide the clip and disconnect the No. 6 water by-pass hose from the water inlet.
    5. Slide the clip and disconnect the radiator reserve tank hose from the water inlet.
    6. Remove the 4 bolts, nut and water inlet.
      GTY460024Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Nut
    7. Remove the No. 1 water inlet housing gasket and water outlet pipe O-ring.
      GTY459831Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 No. 1 Water Inlet Housing Gasket
      *2 Water Outlet Pipe O-ring
  11. REMOVE ENGINE WATER PUMP ASSEMBLY 
    1. Remove the 16 bolts, engine water pump assembly and water pump gasket.
      GTY145177Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals