LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> RC 300 F Sport >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (2GR-FSE) - Service Information >> Thermostat >> Removal [09/2014 - 11/2017] >> Procedure

Removal [09/2014 - 11/2017]: Procedure

  1. REMOVE ENGINE ROOM SIDE COVER 

    Refer to PROCEDURE - Step 1

  2. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 2

  3. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 4 [10/2015 - 11/2017]

  4. REMOVE INLET NO. 1 AIR CLEANER 

    Refer to PROCEDURE - Step 20 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 20 [10/2015 - 11/2017]

  5. REMOVE CENTER NO. 4 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 2 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 2 [10/2015 - 11/2017]

  6. DRAIN ENGINE COOLANT 

    See step  5 [09/2014 - 10/2015], or see step  5 [10/2015 - 11/2017]

  7. DISCONNECT NO. 2 RADIATOR HOSE 
    1. Slide the clip and disconnect the No. 2 radiator hose from the water inlet with thermostat sub-assembly.
      GTY467568Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. DISCONNECT NO. 6 WATER BY-PASS HOSE 
    1. Slide the clip and disconnect the No. 6 water by-pass hose from the water inlet.
      GTY418377Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 
    1. Remove the 3 nuts, water inlet with thermostat sub-assembly and gasket.
      GTY414172Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals