LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> RC 300 F Sport >> Repair and Diagnosis >> Electrical >> Charging Systems >> Generator (2GR-FSE) - Service Information >> Generator >> Removal [09/2014 - 11/2017] >> Procedure

Removal [09/2014 - 11/2017]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [09/2014 - 11/2017]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [09/2014 - 10/2015] , or refer to INITIALIZATION [10/2015 - 11/2017]

  3. REMOVE ENGINE ROOM SIDE COVER 

    Refer to PROCEDURE - Step 1

  4. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 2

  5. REMOVE V-RIBBED BELT 

    Refer to REMOVAL [09/2014 - 11/2017]

  6. REMOVE CENTER NO. 4 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 2 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 2 [10/2015 - 11/2017]

  7. DRAIN ENGINE COOLANT 

    Refer to PROCEDURE - Step 5 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 5 [10/2015 - 11/2017]

  8. REMOVE NO. 1 RADIATOR HOSE 
    1. Slide the 2 clips and remove the No. 1 radiator hose.
      GTY503586Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE NO. 2 ENGINE COVER 

    Refer to PROCEDURE - Step 3

  10. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY 
    1. Remove the bolt, No. 2 idler pulley cover plate and No. 2 idler pulley sub-assembly.
      GTY402203Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE GENERATOR ASSEMBLY 
    1. Disconnect the cooling fan ECU connector.
      GTY503605Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and disconnect the engine wire bracket.
      GTY496857Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Terminal Cap
    3. Remove the terminal cap.
    4. Remove the nut and disconnect the engine wire from terminal B.
    5. Disconnect the generator assembly connector, and disengage the 2 clamps.
    6. Remove the nut.
      GTY458167Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Remove the 2 bolts and generator assembly.
      GTY398398Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Remove the bolt and generator bracket.
      GTY462228Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    9. Remove the bolt and wire harness bracket.
    10. Using an E6 "TORX" socket wrench, remove the stud bolt.
      GTY462229Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals