CD cannot be Inserted / Played or CD is Ejected Right After Insertion [09/2014 - 11/2017]: Procedure
- CHECK IF A PROPER CD IS INSERTED
- Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
OK
CD is normal.
HINT:
- Translucent or uniquely-shaped CDs cannot be played.
- CDs with adhesive paper labels should not be played.
- Commercial audio CDs can be played.
- CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.
- MP3, WMA and AAC files on CD-ROMs, CD-Rs and CD-RWs can be played.
- For details on playable CDs, refer to Owner's Service Information.
Result
Proceed to OK NG
Result:
NG
END (CD IS FAULTY)
Result:
OK
See step 2
- Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.
- CHECK THAT CD IS INSERTED PROPERLY
Result:
NG
SET CD PROPERLY
Result:
OK
See step 3
- CLEAN CD AND RECHECK
- Disc cleaning
- If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.
OK
Malfunction disappears.
NOTE:Do not use a conventional record cleaner or anti-static preservative.
Result
Proceed to OK NG - If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.
Result:
OK
END (CD WAS DIRTY)
Result:
NG
See step 4
- Disc cleaning
- REPLACE CD AND RECHECK
- Replace the CD with a known good one and check that the malfunction disappears.
OK
Malfunction disappears.
Result
Proceed to OK NG
Result:
OK
END (CD WAS FAULTY)
Result:
NG
REPLACE RADIO RECEIVER ASSEMBLY. Refer to REMOVAL [09/2014 - 11/2017]
- Replace the CD with a known good one and check that the malfunction disappears.