LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> NX 200t Base, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio / Video System (Except 8 Speakers) - Diagnostic Codes & Symptom Tests >> AUDIO AND VISUAL SYSTEM (Except 8 Speakers) >> DTC B15C0: Short in GPS Antenna; DTC B15C1: Open in GPS Antenna [10/2014 - 09/2017] >> Procedure

DTC B15C0: Short in GPS Antenna; DTC B15C1: Open in GPS Antenna [10/2014 - 09/2017]: Procedure

  1. CHECK DTC 
    1. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]

      Body Electrical > Navigation System > Clear DTCs 

    2. Recheck for DTCs and check that no DTCs are output.

      Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]

      Body Electrical > Navigation System > Trouble Codes 

      OK

      No DTCs are output.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] 

    Result: 

    NG 

    See step  2

  2. CHECK CONNECTION OF NAVIGATION ANTENNA ASSEMBLY 
    1. Check if the navigation antenna assembly is securely connected to the radio receiver assembly.

      OK

      Navigation antenna assembly is securely connected.

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    SECURELY CONNECT NAVIGATION ANTENNA ASSEMBLY 

    Result: 

    OK 

    See step  3

  3. INSPECT NAVIGATION ANTENNA ASSEMBLY 
    1. Remove the navigation antenna assembly.

      Refer to REMOVAL [10/2014 - 09/2017]

    2. Inspect the navigation antenna assembly.

      Refer to INSPECTION [10/2014 - 09/2017]

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE NAVIGATION ANTENNA ASSEMBLY. Refer to  REMOVAL [10/2014 - 09/2017] 

    Result: 

    OK 

    See step  4

  4. INSPECT ANTENNA CORD SUB-ASSEMBLY 
    1. Remove the antenna cord sub-assembly.

      Refer to REMOVAL [10/2014 - 09/2017]

    2. Inspect the antenna cord sub-assembly.

      Refer to INSPECTION [10/2014 - 09/2017]

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE ANTENNA CORD SUB-ASSEMBLY. Refer to  REMOVAL [10/2014 - 09/2017] 

    Result: 

    OK 

    See step  5

  5. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - ANTENNA CORD SUB-ASSEMBLY) 
    1. Disconnect the I109 radio receiver assembly connector.
    2. Disconnect the I147 antenna cord sub-assembly connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      I109-1 (GPS) - I147-1 (GPS) Always Below 1 Ω
      I109-1 (GPS) or I147-1 (GPS) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE RADIO RECEIVER ASSEMBLY. Refer to  REMOVAL [10/2014 - 09/2017] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR