Removal [09/2015 - ]: Procedure

See step  5

1. Remove the bolt, clamp and gasket.
2. Remove the tailpipe from the 2 exhaust pipe supports.
3. Remove the bolt and clamp, and then disconnect the tailpipe from the center exhaust pipe.

1. Remove the 2 bolts and exhaust pipe damper from the tailpipe.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 4 bolts and 2 compression springs.
2. Remove the center exhaust pipe from the 3 exhaust pipe supports.
3. Remove the 2 gaskets from the front exhaust pipe and front No. 2 exhaust pipe.

1. Disconnect the air fuel ratio sensor connector and detach the wire harness clamp from the bracket.
2. Disconnect the heated oxygen sensor connector.
3. Remove the bolt and disconnect the wire harness clamp bracket of the heated oxygen sensor from the transmission.
4. Remove the 3 nuts, front No. 2 exhaust pipe and gasket from the exhaust manifold LH.

1. Disconnect the air fuel ratio sensor connector and detach the wire harness clamp from the bracket.
2. Disconnect the heated oxygen sensor connector.
3. Remove the bolt and disconnect the wire harness clamp bracket of the heated oxygen sensor from the transmission.
4. Remove the 3 nuts, front exhaust pipe and gasket from the exhaust manifold RH.

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 2