LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> LX 570 >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (Service Information) >> Oil Pressure Sensor >> Installation [09/2015 - ] >> Procedure

Installation [09/2015 - ]: Procedure

  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY 
    1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.
      GTY120966Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      NOTE:
      GTY541116Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Do not allow adhesive to contact the oil hole.

    2. Install the oil pressure sender gauge.
      GTY571679Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

      NOTE:

      Do not start the engine within 1 hour after installation.

    3. Connect the sender gauge connector.
      GTY593084Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. ADD ENGINE OIL 

    See step  6, or see step  6 [08/2020 - ]

  3. INSPECT FOR OIL LEAK 

    See step  7, or see step  7 [08/2020 - ]

  4. INSPECT ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 2

  5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 19

  6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 15

  7. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH 

    Refer to PROCEDURE - Step 16

scientia non olet · About LEMON Manuals