Fuel Receiver Gauge Malfunction [09/2015 - ]: Procedure

1. Check for DTCs. Refer to DTC B1500: Fuel Sender Open Detected [09/2015 - ] ).
   RESULT
   
   

   Result	Proceed to
   DTC B1500 is not output	A
   DTC B1500 is output	B

Result: 

B 

GO TO DTC B1500 

Refer to DTC B1500: Fuel Sender Open Detected [09/2015 - ] )

Result: 

A 

See step  2

1. Operate the Techstream according to the display and select Active Test. Refer to DATA LIST / ACTIVE TEST [09/2015 - 08/2017] , or refer to DATA LIST / ACTIVE TEST [08/2017 - ] ).
   COMBINATION METER
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Fuel Meter Operation	Fuel receiver gauge	OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full, Sender F	Perform the test with the vehicle stopped and engine idling.

   OK

   Needle indication is normal.

Result: 

OK 

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE 

Refer to PROBLEM SYMPTOMS TABLE [09/2015 - 08/2016] , or refer to PROBLEM SYMPTOMS TABLE [08/2016 - 08/2017] , or refer to PROBLEM SYMPTOMS TABLE [08/2017 - 08/2019] , or refer to PROBLEM SYMPTOMS TABLE [08/2019 - 08/2020] , or refer to PROBLEM SYMPTOMS TABLE [08/2020 - ] )

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY 

Refer to REMOVAL [09/2015 - ] )