Entire Combination Meter does not Operate [09/2015 - ]: Procedure

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the combination meter assembly connector.
2. Measure the voltage according to the value(s) in the table below

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   E120-21 (B) - Body ground	Always	11 to 14 V
   E120-22 (IG+) - Body ground	Engine switch on (IG)	11 to 14 V

3. Measure the resistance and voltage according to the value(s) in the tables below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E120-20 (ET) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   * a	Rear view of wire harness connector (to Combination Meter Assembly)

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY 

Refer to REMOVAL [09/2015 - ] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR