Installation [09/2015 - ]: Procedure

INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER
1. Install the tire pressure warning ECU and receiver with the bolt.
  for Black Bolt
  
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  
  for Silver Bolt
  
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  NOTE:
  The torque value differs depending on whether the bolt is silver or black.
2. Connect the connector.
INSTALL TELEMATICS TRANSCEIVER
(Refer to INSTALLATION [09/2015 - ] )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [09/2015 - ] ).
REGISTRATION OF TRANSMITTER ID
(Refer to REGISTRATION [09/2015 - ] )
INSPECT TIRE PRESSURE WARNING SYSTEM
(Refer to TEST MODE PROCEDURE [09/2015 - ] )
PERFORM INITIALIZATION
(Refer to INITIALIZATION [09/2015 - ] )