Removal [09/2015 - ]: Procedure

1. Remove the 8 bolts and the No. 2 engine under cover.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 2 nuts and the front stabilizer link.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

HINT: 

Remove the RH side following the same procedures as the LH side.

1. Remove the 2 screws and the engine under cover sub-assembly LH from the front suspension member reinforcement LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Remove the RH side following the same procedures as the LH side.

1. Remove the 2 screws and the engine under cover rear LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Remove the RH side following the same procedures as the LH side.

1. Remove the 2 bolts and the front No. 1 stabilizer bracket LH from the front suspension crossmember.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Remove the RH side following the same procedures as the LH side.

1. Remove the front stabilizer bar from the vehicle.

1. Remove the 2 front No. 1 stabilizer bar bushes from the front stabilizer bar.

1. Remove the 4 bolts and front suspension member reinforcement LH from the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Remove the RH side following the same procedures as the LH side.