LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> LS 460 L, RWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System - Service Information >> Oil Pressure Switch >> Installation [09/2015 - ] >> Procedure

Installation [09/2015 - ]: Procedure

  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Apply adhesive to 2 or 3 threads of the switch.
      GTY668238Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    2. Using a 24 mm deep socket wrench, install the switch.

      Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

      NOTE:

      Do not start the engine within 1 hour after installation.

    3. Connect the switch connector.
  2. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 13

  3. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (for AWD) 

    Refer to PROCEDURE - Step 15

  4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for AWD) 

    Refer to PROCEDURE - Step 16

  5. INSPECT FOR ENGINE OIL LEAK 
    1. Start the engine. Make sure that there are no oil leaks from the area that was worked on.
scientia non olet · About LEMON Manuals