Removal [09/2015 - ]: Procedure

DISABLE AUTOAWAY/RETURN FUNCTION
1. Disable the autoaway/return function by changing the customize parameter (Refer to CUSTOMIZE PARAMETERS [09/2015 - ] ).
  NOTE:
  Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.
  
  HINT:
  
  Performing the above operation causes the autoaway/return function to be disabled when the engine switch is turned off.
2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully retract and tilt up the steering column assembly.
3. Turn the engine switch off.
REMOVE INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 6
REMOVE INSTRUMENT PANEL ORNAMENT
Refer to PROCEDURE - Step 7
REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Refer to PROCEDURE - Step 8
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
See step 8

REMOVE TRIP SWITCH

w/o Night View System:

Detach the 2 claws and remove the trip switch from the No. 2 instrument cluster finish panel sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

w/ Night View System:

Detach the 2 claws and remove the trip switch from the No. 2 instrument cluster finish panel sub-assembly.