LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> LS 460 L, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel Safety Pad (Service Information) >> Instrument Panel Safety Pad >> Reassembly [09/2015 - ] >> Procedure

Reassembly [09/2015 - ]: Procedure

  1. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY 
    GTY407535Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Attach the 4 claws to install the No. 1 instrument panel register assembly.
  2. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY 
    GTY407534Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Attach the 4 claws to install the No. 2 instrument panel register assembly.
  3. INSTALL NO. 1 METER HOOD RETAINER 
    1. Install the 2 No. 1 meter hood retainers with the 2 screws.
  4. INSTALL NO. 1 INSTRUMENT PANEL PIN 

    HINT: 

    Use the same procedure to install the No. 1 instrument panel pin on the other side.

    1. Install the No. 1 instrument panel pin with the screw.
  5. INSTALL NO. 2 INSTRUMENT PANEL WIRE 
    1. w/o Ion Generator:

      Attach the wire harness clamp to install the No. 2 instrument panel wire.

    2. w/ Ion Generator:

      Attach the 5 wire harness clamps to install the No. 2 instrument panel wire.

  6. INSTALL AUTOMATIC LIGHT CONTROL SENSOR 
    GTY121854Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Attach the 2 claws to install the automatic light control sensor.
    2. Connect the connector.
  7. INSTALL NAVIGATION ANTENNA ASSEMBLY 

    Refer to PROCEDURE - Step 1

  8. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY 

    Refer to PROCEDURE - Step 1

  9. INSTALL NO. 2 INSTRUMENT PANEL WIRE 

    Refer to PROCEDURE - Step 2

  10. INSTALL ION GENERATOR SUBASSEMBLY (w/ Ion Generator) 

    Refer to PROCEDURE - Step 1

  11. INSTALL NO. 2 HEATER TO REGISTER DUCT 
    1. Install the No. 2 heater to register duct with the 2 screws.
    2. w/ Ion Generator:

      Connect the hose to the ion generator sub-assembly.

  12. INSTALL DEFROSTER NOZZLE ASSEMBLY 
    1. Install the defroster nozzle assembly with the 3 screws.
  13. INSTALL NO. 3 HEATER TO REGISTER DUCT 
    1. Install the No. 3 heater to register duct with the 3 screws.
  14. INSTALL NO. 1 HEATER TO REGISTER DUCT 
    1. Install the No. 1 heater to register duct with the 3 screws.
  15. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT 
    1. Attach the claw to install the No. 2 side defroster nozzle duct.
    2. Install the screw.
  16. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT 
    1. Attach the claw to install the No. 1 side defroster nozzle duct.
    2. Install the screw.
  17. INSTALL NO. 1 COMBINATION METER BRACKET 
    1. Install the No. 1 combination meter bracket.
scientia non olet · About LEMON Manuals