Odo/Trip Switch Malfunction [09/2015 - ]: Procedure

1. Operate the Techstream according to the display and select "Data List".

   OK

   Switch condition (ON/OFF) can be switched by actual operation.

   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   ODO/TRIP Change SW	Trip switch (ODO/TRIP switch) condition / ON or OFF	ON: Trip switch (ODO/TRIP switch) pushed OFF: Trip switch (ODO/TRIP switch) not pushed	-
   Trip Reset SW	Trip switch (RESET switch) condition / ON or OFF	ON: Trip switch (ODO/TRIP switch) pushed OFF: Trip switch (ODO/TRIP switch) not pushed	-

Result:  OK

OK 

REPLACE NO. 1 METER ECU 

(Refer to DISASSEMBLY [09/2015 - ] )

Result:  NG

NG 

See step  2

1. Remove the trip switch (Refer to REMOVAL [09/2015 - ] ).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Switch Condition	Specified Condition
   5 (RSET) - 6 (E)	RESET switch ON (Pushed)	Below 1 Ω
   	RESET switch OFF (Not pushed)	10 kΩ or higher
   7 (A/B) - 6 (E)	ODO/TRIP switch ON (Pushed)	Below 1 Ω
   	ODO/TRIP switch OFF (Not pushed)	10 kΩ or higher

Result:  NG

NG 

REPLACE TRIP SWITCH 

(Refer to REMOVAL [09/2015 - ] )

Result:  OK

OK 

See step  3

1. Disconnect the L10 ECU connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Disconnect the L45 switch connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Condition	Specified Condition
   L10-4 (A/B) - L45-7 (A/B)	Always	Below 1 Ω
   L10-5 (RSET) - L45-5 (RSET)
   L45-6 (E) - Body ground
   L10-4 (A/B) or L45-7 (A/B) - Body ground	Always	10 kΩ or higher
   L10-5 (RSET) or L45-5 (RSET) - Body ground

Result:  OK

OK 

REPLACE NO. 1 METER ECU 

(Refer to DISASSEMBLY [09/2015 - ] )

Result:  NG

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR