Installation [04/2013 - 08/2015]: Procedure

WARNING: This page is about a different car, the 2015 Lexus IS 250 and 2014 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL PUMP CONTROL ECU BRACKET
1. Install the fuel pump control ECU bracket with the 2 screws.
  Torque: 3.0 N.m (31 kgf/cm, 27 in.lbf)

INSTALL FUEL PUMP CONTROL ECU

Install the fuel pump control ECU to the body with the nut.
Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)

NOTE:
Do not reuse the fuel pump control ECU if it has been dropped or subjected to a severe impact.
Connect the fuel pump control ECU connector.

Install the 4 clips (A).

Install the a new clip (B).
Install the rope hook assembly with the bolt.
Engage the 2 claws to close the cover.

INSTALL FRONT UPPER LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 6
INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Refer to PROCEDURE - Step 2
INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER (for Fixed Seat Type)
Refer to PROCEDURE - Step 13
INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER (for Fold Down Seat Type)
Refer to PROCEDURE - Step 14
INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 15
INSTALL DECK SIDE TRIM BOX RH
Refer to PROCEDURE - Step 16
INSTALL DECK SIDE TRIM BOX LH
Refer to PROCEDURE - Step 17
INSTALL SPARE WHEEL COVER TRAY RH
Refer to PROCEDURE - Step 18
INSTALL SPARE WHEEL COVER TRAY LH
Refer to PROCEDURE - Step 19
INSTALL LUGGAGE COMPARTMENT FLOOR MAT
Refer to PROCEDURE - Step 20