LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Fuel System (8AR-FTS) - Service Information) >> Fuel Sender Gauge Assembly >> Inspection [08/2015 - ] >> Procedure

Inspection [08/2015 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FUEL SENDER GAUGE ASSEMBLY 
    1. Check that the float moves smoothly between F and E.
      GTY459292Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Fuel Sender Gauge Assembly)
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Float Level Specified Condition
      1 - 2 F 6.5 to 8.5 Ω
      Between F and E 6.5 to 199.4 Ω (Gradually changes)
      E 194.4 to 199.4 Ω
      1. If the result is not as specified, replace the fuel sender gauge assembly.
  2. INSPECT NO. 2 FUEL SENDER GAUGE ASSEMBLY 
    1. Check that the float moves smoothly between F and E.
      GTY468194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (No. 2 Fuel Sender Gauge Assembly)
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Float Level Specified Condition
      1 - 2 F 6.5 to 8.5 Ω
      Between F and E 6.5 to 216.1 Ω (Gradually changes)
      E 210.1 to 216.1 Ω
      1. If the result is not as specified, replace the No. 2 fuel sender gauge assembly.
scientia non olet · About LEMON Manuals