LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2017 >> IS 300 F Sport >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Fuel System (8AR-FTS) - Service Information) >> FUEL PRESSURE SENSOR (for High Pressure) >> Removal [08/2015 - ] >> Procedure

Removal [08/2015 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus IS 300, 2023 Lexus IS 300, 2022 Lexus IS 300, 2021 Lexus IS 300, and 2020 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY (FUEL PRESSURE SENSOR) 

    Refer to REMOVAL [08/2015 - ] 

    NOTE:
    • Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly.
    • If the fuel pressure sensor is removed, replace the fuel delivery pipe sub-assembly (fuel pressure sensor) with a new one.
  2. REMOVE FUEL PIPE SUPPORT SUB-ASSEMBLY (for Type A) 
    1. Secure the fuel delivery pipe sub-assembly in a vise between aluminum plates.
      NOTE:

      Do not overtighten the vise.

      GTY638962Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a 5 mm socket hexagon wrench, remove the 2 bolts, gasket and fuel pipe support sub-assembly from the fuel delivery pipe sub-assembly.
    3. Remove the dust cap sub-assembly from the fuel pipe support sub-assembly.
    4. Remove the O-ring, No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring and No. 3 fuel injector back-up ring from the fuel pipe support sub-assembly.
    5. Remove the fuel delivery pipe sub-assembly from the vise.
scientia non olet · About LEMON Manuals